Order by phone 1-888-401-1362
  

 Shop Flowmaster  Exhaust from Marken Performance 1-888-401-1362

 
Flowmaster cat-back exhaust # 817614 fits 2013-15 Toyota Tacoma with a 4.0L V6 engine; all wheelbases except Standard Cab and X-Runner.  Rear or 4 wheel drive.  It features a Super 50 series muffler and mandrel-bent 2.5” piping throughout. It has a dual side exit with 2 3.5” tips.  Call Marken Performance for this direct bolt-on system that delivers increased performance and mileage with a deep but moderate tone inside and out. Made in the USA, the system carries Flowmaster's lifetime limited warranty for long term quality assurance and includes all necessary installation hardware.  
  

 

 

Flowmaster's Force II Axle-back exhaust system # 817693 fits the 2012-2014 Jeep Wrangler V6 3.6L, either 2 or 4 wheel drive.  This is for the person looking for a moderate exterior and mild interior exhaust tone, with all of the performance benefits that you would expect from Flowmaster.  This bolt-on SOR (Single Out Rear) emissions-legal system for the 3.6L V6 features a stainless steel Super 50 muffler and a single 2.5” stainless steel mandrel bent tailpipe. The system finishes with a 3” brushed stainless steel tip 11” long.  The exhaust system is manufactured in the USA and is covered by Flowmaster's Lifetime Limited Warranty.  Designed for an easy fit, this system includes all necessary parts and hardware for installation. 

  •       Dyno Tuned For Maximum Performance
  •       Patented Delta Flow Technology
  •       Lifetime Limited Warranty
  

 

 

Flowmaster Force II Crossmember-back system # 817661 for the 1974-1979 350 cu in V8 Chevrolet Corvette is perfect for the person looking for a moderate exterior and mild interior exhaust tone, with all of the performance benefits that you would expect from Flowmaster. This bolt-on DOR (Dual Out the Rear) system for the 5.7L V8 features specially tuned stainless steel 60 Series Delta Flow mufflers, a Scavenger X-pipe assembly and 2.25” 409S stainless steel pipes. Like all Flowmaster systems, the pipes are all mandrel bent to reduce any restrictions and maximize performance. The system finishes with 3.” polished 304S stainless steel tips. The exhaust system is manufactured in the USA and is covered by Flowmaster's Lifetime Limited Warranty.

Comment Post Comment

Join Our Newsletter